rapzak

Hi if i remember right it was 2gb... I have upgraded so can't remember too much /Kasper

I have 2gb ram also...

I want to be able to flash it back again if nescessary...

If you use xpenology, you can change the ini file to match your vid/pid of the new disk... else i presume not. It was difficult, and like mentioned you need to find the right drive with right controller, find the production tool, understand it etc. i used many hours for that...

Hi, I will not share my disk - sadly to risky. I managed to change the vid/pid on the above stick on the hole pcb... However, i have run xpenology on the ds710+ since my above post - waiting to see DSM7 - and the i properly get the DS720+.. So you can run xpenolgy on the DS710+ - and it runs quite okay - litle slow but ok. The LED on the front and the fan seems not to be controlled correctly, however, nothing breaks and fan is litle noisy.

Hi, I made a new USB flash disk, and installed internally on the original connector. Used another flash drive as well. But still will only when i connect other USB stuff on the back. Anyone have a comment for that? I think it is strange /Rapzak

Hi, I have installed on a DS710+ with usbstick in front. Used 3615 1.03 bootloader (latest) All seems good, but i have issues with booting regarding how many usb devices there are connected. example - if none other than the usb drive is connected in front, it will boot loop, and write it can not find partition. If i add a keyboard in usb in the back, it boots nice - also if i add a zigbee dongel... Any clues? I have used a usb to SD card to make the boot drive - is it too low quality HW? /Rapzak