Hello I am new to the XPEnology Community, I am interested in making use of an existing NAS device, a Netgear Ready NAS 102
It has a Marvell Armada 370 1.2GHz CPU, and 512MB ram, I have managed to access the serial port provided on the rear of the NAS,
Currently in the process of finding out more about the Marvel Uboot loader, and Nand configuration...
U-Boot 2011.12-gec25d27-dirty (Oct 26 2015 - 16:53:05) Marvell version: v2011.12 2014_T2.0p1
06/23/2015 ReadyNAS-102 V2.0
Board: DB-88F6710-BP
SoC: MV6710 A1
CPU: Marvell PJ4B v7 UP (Rev 1) LE
CPU @ 1200 [MHz]
L2 @ 600 [MHz]
I have had a go at booting Xpenology on the ready nas using uboot,
Marvell>> dhcp
egiga1 wait for link ....... no link (wait 6000 ms)
Marvell>> dhcp
egiga1 wait for link .Done - link up.
BOOTP broadcast 1
DHCP client bound to address 192.168.1.118
Marvell>> setenv serverip 192.168.1.41404
Marvell>> tftp uImage
Using egiga1 device
TFTP from server 192.168.1.104; our IP address is 192.168.1.118
Filename 'uImage'.
Load address: 0x2000000
Loading: *#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
########################################################
done
Bytes transferred = 18937488 (120f690 hex)
Marvell>> bootm $load_addr
## Booting kernel from Legacy Image at 02000000 ...
Image Name: Linux kernel
Created: 2019-01-07 22:38:04 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 18937424 Bytes = 18.1 MiB
Load Address: 80008000
Entry Point: 80008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
Starting kernel ...
But if I am honest its a big learning curve for me, and would appreciate a push in right direction...