msxsnow

Thanks Mate. I've managed to fiddle the settings on the SG200-08 as well, and done with the XPE part. Now it did shows successful on the Control Panel with 2000MB with my 2 NIC. However, once this show successful, all the connection to my ESXi Host or other VM will become inaccessible. Not sure if others did encounter the same problem, I have been reading around on net, and noticed something about VDS. Is it something that I have to do in-order to have the VM XPE performing Link Aggregation, while still allowing the VM Host serving other Guest VMs ? Cheers,

Dear Group, Has any master have experience on setting up link aggregation with XPE 5.1-4 under ESXi ? I have an HP G8 with ESXi installed, running XPE 5.1-4 without any problem. And now I am looking at activating the link aggregation on it. I have created 2 Port and connected 2 LAN, and attached to the XPE VM, and both working no problem (detect and assigned IP from Server), however, once I created the Bond on XPE, it will dominate my network, renders all my other VM inaccessible. If I remove the bond or even just disconnect 1 LAN cable, all my other VM will become normal and accessible. Appreciate if any master can guide me through this to have it setup ~ Cheers !

Hi There. I am currently on the same boat, while I'm still running on an earlier Trantor 4.2-3202 over ESXi, I am worried about the upgrade will wipe out the Data. If anyone can advise a workable step by step procedure, I would be much appreciated. Cheers !