Jump to content
XPEnology Community

olafd

Rookie
  • Posts

    1
  • Joined

  • Last visited

Everything posted by olafd

  1. Hi, i'm fairly new to xpenology. i have managed to run it in virtual box just to see if i can get it working. now i was trying to re-use an ancient dell precision 650 workstation with two x86 XEON CPUs and 2gb RAM to run xpenology, following the steps as outlined here by the thread starter. i can boot the image from usb fine and connect to it via the Synology Assistant. when i start the installation, supplying DS411-1067-x86-20130525.pat to SA, i get a server error with code no. 38. on the servers console i can see the following messages: EXT3-fs: unable to read superblock EXT2-fs: unable to read superblock FAT: unable to read boot sector NTFS-fs error (device md0): ntfs_fill_super(): Unable to determine device size. the problem migth be that the RAID adapter that's in the box might not be supported. it's a DELL Perc 320/DC card with 4 SCSI drives attached. i think it's actually an adaptec controller as the bios configuration and setup menus look a lot like the old adaptec scsi setup menus. can anybody tell me if i have any chance in using this setup? if not, i might have to buy a PCI SATA card to replace the Perc adapter but i'd like to avoid that for the time being. don't want to throw to much money at the box without knowing if the whole setup will work in the end… thanks, o
×
×
  • Create New...