gn28

Once it boots, can I ssh to xpwnology to run thise commands?

Can anyone please help me identify which drivers are needed (SATA drivers most likely) so I can run Xpenology on my QNAP TVS-473 ? Thanks in advance!

How did you manage to get past this Bios issue? Thanks in advance Look in setup BIOS for running at startup USB key in UEFI or MBR mode ( key ESC ) Also possible problems with HDD Marvell controller or AMD CPU I tried all the boot options, but so far none is able to load the SATA drivers (aka the installer does not see the drives). Any ideas?

@fonix232 - what commands must I run?

How did you manage to get past this Bios issue? Thanks in advance

Well you have a nice box with the QNAP, they are not bad the interface isn't as nice as Synology its gotten a little better with the newest beta. I think the main issue here is the box you have is an AMD version and xpenology boot loaders don't have the proper drivers for your hardware so you might be SOL on a baremetal install but you could always run it as a virtual machine and pass the maximum resources to the VM , i think you will be surprised on how decent it will run.. You could also sell it on ebay or something else, they hold there value and then you could get the synology box you want That's where it is really strange, because xpenology boots just fine, it finds the network cards, but it does not find my hard drives for some reason. I will give it a few more tries with older versions. Otherwise I will go with your suggestion and hope someone buys it on ebay.

I'll take a look at your link... 5.2 boots fine and I can see it in the network, but it just says "No hard disk found" even though I tested the drives and my DS214+ sees them just fine.... and I even have a 256gb m.2 SSD in yeah... no luck so far... man this is such a pity.. something is really wrong... I'll be really sad if I have to throw away this nice qnap box

So far I seem to have no luck figuring out how to install the 6.0 version... I guess I'll try something older... what a pity. I boot and no matter what I chose I do not see anything in the network on find.synology.com

Hi everyone, I just received a tvs-473 as a gift. My first choice would have been a synology box, but that's life. Can someone please explain to or point me to the relevant link so I will know how to install synology 6.x on my qnap box? I know how to get into the bios (F7) and boot from a usb stick but that's as far as my knowledge goes. Thanks in advance