dutchnas
-
Posts
35 -
Joined
-
Last visited
-
Days Won
2
dutchnas's Achievements
Junior Member (2/7)
4
Reputation
-
New update: I'm done to get this working and bought an DS918+. I've been using Xpenology using for years but now I'm at the point that I doen't want to investigate every update if it's working or not. Thanks for making this possible on 3rd party hardware.
-
I have an Gen 10 when using the 3617 or 918 bootloader I can start the reinstall option and can connect. But when upgrading and rebooting the nas won't get online anymore. I'm using an intel Nic so that should not be the issue. Does anybody has some suggestions?
-
My mistake I mean both versions turned around.
-
With 1.03b I can't update further then 6.2.1-23824. I've tried 6.2-23739 update 2 but that one isn't supported. That's why I'm asking will there be an update 4 release for the 3615.
-
That is an workaround I saw on the forum. But my concern is that the 3615 bootloader is dropped and then 6.2 is the last version for my N40L. That's why I ask the question if the 3615 will be developed?
-
Will there be an 3615 release as well? Because my old N40L won't support the newer boot loader.. 🙁
-
That was the trick, thank you! 😀
-
But I don't understand that one for now, I need to use the zImage, extra.gz and rd.gz from another image but which one? How to downgrade: Replace zImage, extra.gz and rd.gz (open synology.img -> image.img with 7Zip) with the one from DS3615xs (use the opposite of what you have installed currently) so you will force a reinstall of DSM. You cannot migrate the settings, so you have to do a clean install (keeps your data). Afterwards replace the above files again with your original bootloader, for me its DS3617xs and do a fresh install again.
-
Today I've tried to upgrade my HP N40L Microserver but the onboard nic won't work anymore. I want to rollback to DSM 6.2-23739 Update 2. I've tried the following; Flashed my USB with the latest bootloader 1.03b and starter the NAS. The NAS is reachable but only has the recovery option, but after the recovery the nic isn't reachable again. How can I force the install to use DSM 6.2.1-23824, and hopefully without any data loss only config loss.
-
- Outcome of the installation/update: UNSUCCESSFUL - DSM version prior update: DSM 6.2-23739 Update 2 - Loader version and model: JUN'S LOADER v1.03b - DS3615xs - Using custom extra.lzma: NO - Installation type: Baremetal - HP Proliant Microserver N40L -Additional Comments: Manual reset but the onboard NIC isn't reachable anymore, had to do a reinstall.
-
It is an onboard NIC from an HP N40L, with DSM 5.2 it was working fine and now with DSM 6.2 it won't work anymore.
-
Currenly I'm running Xpenology with DSM 6.2. I've enabled WOL within DSM on the NIC, but when sending the magic packet nothing happens. How can I get WOL working?
-
That was the solution, thanks!
-
No the HP N40L has no monitor attached.
-
Nobody has some tips for me?
