guyp2k

Just curious if anyone has been successful passing-through an optical/cd-rom via Docker and MakeMKV? Below is the only information I was able to capture from the console w/ out lsscsi, ata3.00: Find SSD disks. [HL-DT-ST BD-RE WH16NS60] [ 1.222754] sdb: sdb1 [ 1.223017] sd 1:0:0:0: [sdb] Attached SCSI disk [ 1.225089] scsi 2:0:0:0: CD-ROM HL-DT-ST BD-RE WH16NS60 1.00 PQ: 0 ANSI: 5 ...and my Docker run comand: docker run -d \ --name=makemkv \ -p 5800:5800 \ -v /volume1/docker/appdata/makemkv:/config:rw \ -v $HOME:/storage:ro \ -v /volume1/Rips/Output:/output:rw \ --device /dev/sdb \ --device /dev/sdb1 \ jlesage/makemkv Runs/installs fine, but when I launch MakeMKV no optical drive is detected, at a loss...any suggestions and is there any process to install "lsscsi" ? Thanks

Using an old Gigabyte GA-Z77X-UDH5 w/ Core I7, 32G RAM, Intel NICs, and both on-board SATA and SATA card. I am able to install 6.2.1 Update 4, but experiencing some issues. The issues are as follows: 1. Will not reboot and power-off, requires a cold power-off. 2. Not all HDs are showing up, show fine in boot, but not DSM. So my question should I try and install an earlier release, 6.1 and upgrade to 6.2.1, if so what loader and version (3615 or 3617) would be the recommendation. Thanks

Thanks, had important updates disabled.

New to Xpeneology - installed in Hyper-V last week and running well. Where and how would you install this update, from Xpenology itself or from the boot screen install/update? Thanks

Currently I have Xpenology running via Hyper-V with no issues other than than the HDs attached to the motherboard SATA controllers. I purchased a LSI controller and will move the HDs over to that controller. Once I move the drives over to the new controller I assume I will lose the RAID set and data or will the RAID set and data stay intact? Thanks