Jump to content
XPEnology Community

guyp2k

Transition Member
  • Posts

    5
  • Joined

  • Last visited

guyp2k's Achievements

Newbie

Newbie (1/7)

0

Reputation

  1. Just curious if anyone has been successful passing-through an optical/cd-rom via Docker and MakeMKV? Below is the only information I was able to capture from the console w/ out lsscsi, ata3.00: Find SSD disks. [HL-DT-ST BD-RE WH16NS60] [ 1.222754] sdb: sdb1 [ 1.223017] sd 1:0:0:0: [sdb] Attached SCSI disk [ 1.225089] scsi 2:0:0:0: CD-ROM HL-DT-ST BD-RE WH16NS60 1.00 PQ: 0 ANSI: 5 ...and my Docker run comand: docker run -d \ --name=makemkv \ -p 5800:5800 \ -v /volume1/docker/appdata/makemkv:/config:rw \ -v $HOME:/storage:ro \ -v /volume1/Rips/Output:/output:rw \ --device /dev/sdb \ --device /dev/sdb1 \ jlesage/makemkv Runs/installs fine, but when I launch MakeMKV no optical drive is detected, at a loss...any suggestions and is there any process to install "lsscsi" ? Thanks
  2. Using an old Gigabyte GA-Z77X-UDH5 w/ Core I7, 32G RAM, Intel NICs, and both on-board SATA and SATA card. I am able to install 6.2.1 Update 4, but experiencing some issues. The issues are as follows: 1. Will not reboot and power-off, requires a cold power-off. 2. Not all HDs are showing up, show fine in boot, but not DSM. So my question should I try and install an earlier release, 6.1 and upgrade to 6.2.1, if so what loader and version (3615 or 3617) would be the recommendation. Thanks
  3. New to Xpeneology - installed in Hyper-V last week and running well. Where and how would you install this update, from Xpenology itself or from the boot screen install/update? Thanks
  4. Currently I have Xpenology running via Hyper-V with no issues other than than the HDs attached to the motherboard SATA controllers. I purchased a LSI controller and will move the HDs over to that controller. Once I move the drives over to the new controller I assume I will lose the RAID set and data or will the RAID set and data stay intact? Thanks
×
×
  • Create New...