I am curious to know if I pull my old and smaller HDD on SATA0 and replace it with the new and bigger HDD with it.
What would happen? Is it going to create a huge mess?
I wish I read your reply a bit earlier, I just clicked and expanding my SHR to 1 disk fault tolerance.
If I take out the original and smaller size hdd and leave the newer and larger hdd in SATA0 after sync, will that create problem?
I want to move the content of my SATA0 hdd to a new and bigger hdd.
Is there an easy way to do it? Are cloning (which software to use?) and gparted the way to go? I tried the hyper backup but it doesn't seem to allow me to restore to a different hdd.
My SATA0 is only 300GB and running out of space. I am using baremetal and running 6.1.3 update 8.
Thanks.
PCIe 3.0 cards are too expensive for me. I think I will stick with PCIe 2.0 card. I think I am taking a speed hit with the PCIe 2.0 card compare with the SATA on board speed?
@IG-88 It would be nice to have updated hardware support list.
Thanks guys.
I found this, will it work?
https://www.amazon.ca/IOCrest-Port-SATA-Controller-Components/dp/B00AZ9T3OU/ref=sr_1_sc_1?ie=UTF8&qid=1507647157&sr=8-1-spell&keywords=io%2Bcrest%2Bsataiii%2Bpci-e&th=1
Any difference between the SE9215 and SE9235?
I am running out of SATA port on the motherboard.
Would like to add a SATA controller card to add more HDD.
Will Marvell 88SE9235 and 88SE9215 work with Jun loader?
My baremetal is running 6.1.3 update 6 with Jun 1.02b loader.
Thanks.
Newbie here.
I installed Xpenology 5.2-5592 on ECS H67H2-M motherboard.
Can I go straight to update 4?
Do I update from the DSM or the install/upgrade menu on the bootloader?