Jump to content
XPEnology Community

All Activity

This stream auto-updates

  1. Past hour
  2. Исходя из выше сказанного, то наверное это лучший выход. И обратите внимание на самосбор, нежели на продукт от Сино. Он будет в разы лучше и дешевле. Тем более, что вы уже на форуме по этой теме )))
  3. Добрый день, боюсь не получится, т.к. проц более нового ничего не поддерживает
  4. Добрый день могу установить на DS120j, Версия DSM 7.2.1.-60057 больше 2х лицензий на камеры?
  5. Today
  6. Par contre, je comprends pas pourquoi le systeme se reserve 4,7go de RAM sur les 8
  7. je n'ai plus de serveur ESXi depuis longtemps. Tout le tuto est basé sur VMWare Workstation et à chaque commentaire remontant un changement je fais l'effort de le maintenir. Maintenant c'est possible que j'ai oublié qqchose mais fondamentalement le tuto doit toujours fonctionner.
  8. ah ben oui clairement. Regarde au niveau de la consommation de ton CPU, il doit être fortement sollicité
  9. Merci de ta réponse. Oui je ne doute pas qu'il soit à jour vu le travail formidable accompli, mais 28 pages, cela fait beaucoup, ou je me trompe de tuto. Je ne sais même plus ou commencer... vu le nombre de rectifs, de mises à jour, etc.
  10. J'suis bien en gigabit Apparement il est encore en train de faire l'optimisation du volume, ca peut tuer autant les perf ?
  11. en général ce type de pb est lié au cablage. Si tu plafonnes aux alentours de 12Mo/s c'est qu'une des interfaces réseaux entre ton NAS et ton DS712 a basculé sur 100Mbits. Vérifie bien toute la chaine.
  12. heu... le tuto est à jour il me semble sauf si j'ai raté qqchose.
  13. Bonjour Vu le nombre de pages, c'est bien mais difficile de s'y retrouver, serait-il possible de refaire un tuto. En vous remerciant d'avance. Bonne journée.
  14. I would like to once again urgently point out the need to back up every DOM of Synology + models. It's done in a few seconds. Simply run via SSH with root: dd if=/dev/synoboot of=/volume1/myShare/DS412+synoboot-6.2.4u5.img where "myShare" is your share for general purpose. Of course, it only makes sense if the file is then downloaded from the Synology to another location.
  15. Проверял на Plex и на SS (DVA1622). Сама ESXi мне не понравилась .. то заработает, то после перезагрузки что-то отвалиться, не стабильная... Ставить на рабочею машину не рискнул.
  16. Came back to answer the question and the answer is probably a no, I didn't try it. My thinking is that the driver seems to be to use the listed hardware and emulate so the virtual DMS can use it. What I did instead was use the following github project. It's actually pretty easy to do, just read the readme and if you get stuck, the author is pretty responsive. The only problem I ran into was that there is one command where you change root and then try to get some data from the repo (if I recall correctly) and it can't because it can't verify certificates. One can download the repo before then, placing it into the root you'll use later. https://github.com/tabrezm/r8125-synology Though there seems to be minimal changes to the driver to get it to compile, I'm not sure it would work for everything. Also my NAS can use newer version of the driver, while the author has not been able to do the same. I'm probably not going to continue looking at this since I got it working and my needs for the NAS seem to need more power... time to look at what this XPEnology project is actually all about!
  17. Salut Je viens de suivre ce tuto pour la remise a zero de mon NAS et passage a DSM 7 Il tourne avec SHR avec 4x4to + 1x3To et j'ai un gros soucis de vitesse d'acces. Apres avoir réimporté mes données, Je viens de lancer un Rsync pour en faire un backup sur un DS712 et je tourne entre 5 et 15mo/s en moyen en transfert sur du gigabit. Depuis mes machines, idem, debit vraiment naze. En DSM 6, j'avais 40 a 50 Mo/s et justement j'suis reparti de zero pour espérer pouvoir taper les 100Mo/s théoriquement possible. Un conseil a me donner ?
  18. HI, I do have a genuine serial number, DS918+. I setup MS 365 and logged in with that, i cannot create anything, as it asks for a works account for MS. So i tried the steps above but keep getting { "error": { "code": 400 }, "success": false } Any workaround for this. Cheers guys / gals
  19. Что работало-то? У меня основная рабочая виртуалка - DS920+, туда проброшена встроенная видюха, /dev/dri есть, транскодинг в Jellyfin работает. А вот с дискретной на DVA3219 (не 1622!) - не хочет что-то...
  20. Тоже когда-то баловался, синька любит на реальном железе
  21. 15 хватает, проверено )
  22. 10Gb - мало, Synology отъедает часть каждого диска под системный раздел. Надо делать где-то от 20Gb...
  23. Можно не одну DVA, а 10 🙃 спроси теме SS у кого ни будь показываетХ265 на ДСМ6. Можно поставить Видеостайшен ей подсунуть видео с камеры. И проверить какие кодыки активировались.
  24. Доброго дня. Подскажите, решил в ESXI8 поставить xpenology dva посмотреть создал машину, на первый контроллер vmdk с загрузчиком arc на второй один диск на 10gb все запустилось, в диски видны в sysinfo, но при установке ругается что не может отформатировать диск контроллер sata стоит, пробовал и ds3617 - также ругается пересоздал все и диск на 50гб и поехало
  25. 8 маловато, тут не в винде дело, скаченное видео винда проигрывает без проблем
  1. Load more activity
×
×
  • Create New...