Jump to content
XPEnology Community

Help removing empty slots in GUI


igorek24

Recommended Posts

Hi all, I'm building new XPEnology NAS and came across this problem, 4 slots are shown empty. I have 4 on-board SATA ports and Dell H310 ( flashed with IT firmware) with 8 ports. I have 2 SSDs plugged in to 2 On board ports and 8 HDDs in to H310 and only 2 SSDs with 6 HDDs are showing up in gui. I tried one of my older motherboard and all of them showed up. How can I disable this 4 empty slots? I did add "rmmod=ata_piix" to my syslinux.cf that removed additional 2 empty slots ( Ihad total of 6).

 

My MANU LABLE:

kernel /zImage  rmmod=ata_piix ihd_num=0 netif_num=4 syno_hw_version=DS3612xs sn=B3J4N01003 vid=0x0EA0 pid=0x2168 loglevel=7 vga=0x305 debug console=ttyS1,115200

My Motherboard:

BIOSTAR Hi-Fi H81S2

expenology.jpg?m=1414811804

Link to comment
Share on other sites

  • 1 month later...

edit

 

/etc.defaults/synoinfo.conf

and

/etc/synoinfo.conf

 

change the section

 

# service limitations

maxaccounts="16000"

maxgroups="512"

maxshares="512"

maxdisks="16" <<<<<<<<<<<<<<<<<<<

maxprinters="2"

maxlogsize="64"

maxvhost="30"

 

save both files, go back to storage manager and wait a minute or two... it should then automagically change.

 

If it does't refresh (which it doesn't seem to do on stupid internet explorer) try a different browser.

 

.

.

Link to comment
Share on other sites

×
×
  • Create New...