Jump to content
XPEnology Community

Black6spdZ

Member
  • Posts

    79
  • Joined

  • Last visited

  • Days Won

    1

Black6spdZ last won the day on October 6 2019

Black6spdZ had the most liked content!

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Black6spdZ's Achievements

Regular Member

Regular Member (3/7)

7

Reputation

  1. Are you saying you need Haswell just to run DSM but not have AI capabilities correct?
  2. I have a 4 drive R6 right at 49% capacity.. I opted to purchase another 10TB drive, do a fresh DSM7 install on that, copy data over "should be finished today" then I'll pull one drive from existing "degrading but still have 1 drive redundancy" and converting new volume to R1.. after that I'll have redundancy on new array and can just add all drives over and convert back to a new 5 drive R6.... OR I could wing it and attempt an upgrade after I at least have a copy of the data on the new drive.. hmmm decisions
  3. direct in-place upgrade? I'm curious how that works because DSM6 uses a ~2.5GB partition and DSM7 uses ~8GB
  4. Is this correct? sudo curl https://raw.githubusercontent.com/Trauma/cpufreq-userspace-scaler/master/install.sh -o /tmp/install.sh && sudo curl https://raw.githubusercontent.com/Trauma/cpufreq-userspace-scaler/master/scaler.sh -o /tmp/scaler.sh && sudo curl https://raw.githubusercontent.com/Trauma/cpufreq-userspace-scaler/master/cpufreq-userspace-scaler.service -o /tmp/cpufreq-userspace-scaler.service && sudo chmod +x /tmp/install.sh && sudo /tmp/install.sh I'm getting sudo: unable to execute ./install.sh: Permission denied should the installer script do all of the above to simplify install?
  5. ideally would be to stay in text mode similar to ARPL
  6. Sure about that? it uses standard SAS2108 chipset
  7. crazy to see so many people that have never worked for any business that values data... building a virtual NAS is asinine
  8. I like ARPL for it's simplicity "no GUI setup" but it doesn't inject drivers for my Realtek 8156 USB 3 2.5GbE adapter even though it uses it during bootloader setup
  9. any news on support for DSM 7.2 RC?
  10. I only had this problem with a SAS2308 controller
  11. Tried this and it still starts at 2.. not sure where the phantom drive 1 is coming from
  12. quick Q, I have a small setup using an SAS HBA " LSI 9211-8i (IT) w/ 4x HDD & 1 SSD" and no onboard SATA. Drive ordering starts at 2 instead of 1 and I haven't been able to figure out how to fix this.. I tried SataPortMap=0 but no go.
  13. unable to delete message...
  14. what controller are you running? I'd never trust my data to a NAS running inside a VM.
×
×
  • Create New...